● Open 24/7 for emergency calls
Stop the Leak for Good: Basement Waterproofing in Fort Washington, MD
We diagnose the actual water source before we quote anything — no guessing, no upsell, just a plan sized to your basement.
We diagnose the actual water source before we quote anything — no guessing, no upsell, just a plan sized to your basement.
Basement waterproofing mistakes usually come down to one thing: fixing the symptom instead of the source. A contractor who paints over a wet wall without checking cove joint condition or exterior grading is setting you up for the same call again in a year or two.
We're bonded and insured for both residential and light commercial basement work across Fort Washington, MD.
Most inspection requests get a same-day or next-day appointment, not a two-week wait.
No hourly billing and no change orders once your basement floor is already open.
Thermal imaging helps us confirm whether a stain is active moisture or an old, already-fixed leak.
Every Fort Washington, MD Basement Waterproofing job starts with an inspection, not a generic package — here's what that typically includes.
We route drain tile beneath the existing slab line so flooring disruption stays minimal during installation.
Every drain tile system needs a properly sized sump pump — we calculate basin size and pump horsepower from your square footage and local water table depth.
Vertical wall cracks get epoxy or polyurethane injection depending on whether they're still actively weeping.
We install membrane on masonry walls before any insulation or framing goes up, so moisture never gets a chance to reach finished materials.
Window wells that hold water after a storm are a direct pressure point against the glass and frame — we add gravel beds and drain lines tied into the main system.
You describe what you're seeing — a wet spot, a musty smell, standing water — and we get a rough read on urgency before dispatching anyone.
We also check exterior grading and downspouts, since a lot of basement leaks start outside, not inside.
We explain the reasoning behind the recommended system so you know exactly what you're paying for and why.
Most residential basement jobs finish in one to three days, and we test the sump pump under load before we leave.
"Our finished basement started smelling musty and we finally found a wet spot behind the drywall. They cut open the cove joint, ran drain tile, and it's been dry for over a year."
— Fort Washington Homeowner
"Water came in around our window well every time it rained hard. They regraded it and added a drain line — problem solved."
— Fort Washington Customer
"They walked us through exactly why the water was coming in before quoting anything, which no one else had bothered to do."
— Fort Washington Homeowner
"Basement had been damp for years. Drain tile and a new sump system fixed it in three days."
— Fort Washington Customer
Every Fort Washington, MD quote is itemized in writing so you can see exactly what drives the total.
Yes — interior drain tile requires cutting a channel along the slab edge, which we patch with concrete once the system is installed.
Most residential interior drain tile and sump installations finish in one to three days depending on basement size.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
Coverage depends on your policy and the cause of the water intrusion — we can document conditions for a claim, but approval is up to your insurer.
Yes, every interior drain tile and sump installation comes with a written warranty, explained in full before you approve the quote.
We install interior drain tile and sump systems throughout Fort Washington and the surrounding Fort Washington, MD service area, including the zip codes listed below.
Zip codes we serve in Fort Washington, MD: 20744 20749
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
